Attention For Operation - Contec CMS-50F User Instructions

would be displayed on the screen, then it returns to the main menu; if you didn't reset the time and
date, when exiting the clock setting menu, the device would return to the main menu directly.
d) Uploading the saved Data
Connect the device to computer with data line, then open the PC software.Please refer to <SpO
2
Assistant user manual> for detailed operation method of uploading data.The software symbol is as
Figure9.
The computer the device is connected to should accord to the standard of IEC60950,and the
system which is composed with the device accord with the requirements of IEC60601-1-1.
Figure 9 Software symbol
e) Device ID
The user can modify the device ID by the software "SpO Assistant".Please refer to <SpO Assistant
2 2
user manual> for detailed operation method.
f) Power off
On the main menu interface, Click the button to select "Power off", then Press the button to shut
down the device.
g) Exit the main menu
On the main menu interface, Click the button to select "Exit", hen Press the button to exit the main
menu.
F. Charge
There are two kinds of charging methods:
a) Connect the device with computer by data line, then the device should be under charging state.
b) C o nnect the device with power supply by power adaptor, then the device should be under charging
state.
When the device is in the state of battering charging, the indication light appears to be orange, and
when the battery status is full, the light turns to green.
If the alarm function is on, the device will provide high-priority alarm signal when the
battery is in low power status .Intermittent alarm will occur and the battery icon turns red in
the state of flashing.
High priority indicating that immediate operator response is required.

6.2 Attention for Operation

A. Please check the device before using, and confirm that it can work normally.
B. The finger should be in a proper position (see the attached illustration of figure 4 for reference), or
else it may result in inaccurate measure.
C. The SpO sensor and photoelectric receiving tube should be arranged in a way with the subject's
2
arteriole in a position there between.
D. The SpO sensor should not be used at a location or limb tied with arterial canal or blood pressure
2
cuff or receiving intravenous injection.
10