Accessories; Operating Guide; Application Method - Contec CMS-60C Instructions Manual

Medical Test Supply

5.4 Accessories

A. A lithium battery
B. A User Manual
C. A power adapter
D. A data line
E. A disk (PC software)
F. An adult-oximeter probe
An infant-oximeter probe ( May purchase selectively)

6 Operating Guide

6.1 Application method

A.
a) Open the lid of battery box and put the battery inside, then close.
b) Put the suitable probe into the jack on the right side of the oximeter. (The probe is limited to be
produced by our company; never replace it with the similar ones by other manufacturers).
c) Put the finger into the probe.
d) Press the "power on/off button" long about a few seconds, the power is on, and the device will
start to self-inspect. The device displays the measuring interface after self-inspecting.
e) Do not shake the finger and keep the patient in a stable state during the process.
f) The data can be read directly from the screen on the measuring interface.
Fingernails and the luminescent tube should be on the same side.
If the alarm function is on, the device will provide medium-priority alarm signal when
probe or finger is out 。 Intermittent alarm will occur and the user interface presents
"FINGER OUT".
Medium priority indicating that prompt operator response is required.
Figure 5
（ Actual probe may be different with the probe as figure 5,please accept the actual probe with the
device ）
B. Change display direction:
CMS-60C