Table C-3. Extended At& Command Set - NETGEAR XM128 ISDN Reference Manual

Table C-3. Extended AT& command set (continued)
Command Options
&Dn
&D0
&D1
&D2 *
&D3
&En
&E0 *
&E1
&F
&Hn
&H0
&H3 *
&H4
&Jn
&J0 *
&J1
&J2
&J3
AT Command Set Reference
Reference Guide for the Model XM128 ISDN Digital Modem
Function and description
Data Terminal Ready (DTR) options. See also S-registers 21.6 to 21.7 and
25. For a description of Extended S-registers, refer to Table D-4 on page D-5
in Appendix D, "Status Registers and Result Codes."
Ignore DTR signal; assume DTR is always on.
108.1, DTR OFF-ON transition causes dialing of the default number. See
also the command AT*Dn and S48.4. For a description of Extended
S-registers, refer to Table D-4 on page D-5 in Appendix D, "Status Registers
and Result Codes."
108.2, Data Terminal Ready, DTR OFF causes the Model XM128 modem to
hang up.
Same as &D2, but DTR OFF causes the Model XM128 modem to hang up
and reset from profile 0.
B channel line speed for ISDN data call. See also S-register 118.2. For a
description of Extended S-registers, refer to Table D-4 on page D-5 in
Appendix D, "Status Registers and Result Codes."
64 Kbps.
56 Kbps (Default for American ISDN).
Load factory settings to RAM as active configuration.
Data flow control, DTE/DCE. See also S-registers 27.3 to 27.5. For a
description of Extended S-registers, refer to Table D-4 on page D-5 in
Appendix D, "Status Registers and Result Codes."
Flow control is disabled.
Hardware (CTS/RTS) flow control is disabled.
Software (XON/XOFF) flow control is disabled.
Bundle selection. See also S-registers 87.5, 87.6 and 100. For a description
of Extended S-registers, refer to Table D-4 on page D-5 in Appendix D,
"Status Registers and Result Codes."
Bundle connection is disabled.
Bundle connection is enabled in answer mode only.
Bundle connection is enabled in call mode only.
Bundle connection is enabled in both directions.
C-9