Description Of Ati3 Output - NETGEAR XM128 ISDN Reference Manual

Table C-1. Basic AT command set (continued)
Command Options
SPIDn=m
SPID0
SPID1
SPID?
UPX
Vn
V0
V1 *
Xn n=0-7
5 *
Zn n=0-4
Zn
Z4
$

Description of ATI3 Output

The Link Status Report output is displayed on the screen as follows:
NETGEAR ISDN Modem LINK STATUS REPORT
Connect DTE Speed
Error Control Level
Protocol Link Speed
Octets Received
Octets Sent
Cause
Cause Value
HDLC FCS Error
HDLC Receive Over-run
HDLC Transmit Under-run : 0
AT Command Set Reference
Reference Guide for the Model XM128 ISDN Digital Modem
Function and description
User enters Service Profile ID (SPID) m, for USA switches.
First SPID number
Second SPID number, if any.
Display the SPID setting(s).
Download firmware to the flash EPROM using X-modem Protocol.
Sets display type for result codes. See also S-register 23.6. For a description
of Extended S-registers, refer to Table D-4 on page D-5 in Appendix D, "Status
Registers and Result Codes."
Displays result code in numeric form. See also S-register 35.7 and the result
code table of ATXn. For a description of Extended S-registers, refer to
Table D-4 on page D-5 in Appendix D, "Status Registers and Result Codes."
Displays result code in verbose form.
Result code options. See the options table. See also S-registers 23.3 to 23.5.
For a description of Extended S-registers, refer to Table D-4 on page D-5 in
Appendix D, "Status Registers and Result Codes."
Resets the Model XM128 modem and sets power-on profile. See also
S-registers15.5 to 15.7. For a description of Extended S-registers, refer to
Table D-4 on page D-5 in Appendix D, "Status Registers and Result Codes."
Resets the Model XM128 modem and loads user profile n (0-3).
Resets the Model XM128 modem and loads factory settings.
Basic command summary help
:
:
:
: 0
: 0
:
: 0
: 0
: 0
C-7