NETGEAR XM128 ISDN Reference Manual page 106

Reference Guide for the Model XM128 ISDN Digital Modem
Table C-1. Basic AT command set (continued)
Command Options
CPn
CP0
CP1
CRn n=0-3
0 *
CSn n=0-3
0 *
Ds
,
+
W
Y0
Y1
Y2
Y3
Y4
Y6
Z0
Z2
N0
N1
N3
N8
N9
/
Format of "s" [[Yn][Nn]called_party_number][[W][,]]inband_dtmf_number
C-4
Function and description
Loopback 4 control
Disable Loopback 4
Enable Loopback 4
Resumes a previously suspended call; n is the call identifier (Europe).
Suspends a call; n is the call identifier (Europe).
Dial s numbers and options that follow. See also S-register 38.0 and 35.4. For
a description of Extended S-registers, refer to Table D-4 on page D-5 in
Appendix D, "Status Registers and Result Codes."
The s options are listed as follows:
Pause for a time specified in S6. Remaining digits are dialed as in-band
DTMF.
Prefix for the second number string, to be used in making bundling or MPPP
calls.
Wait for second dial tone. Remaining digits are dialed as in-band DTMF (ISDN
numbering options).
Unknown type of number
International number
National number
Network-specific number
Subscriber number
Abbreviated number
Type of subaddress, NSAP with AFI=$50, IA5 characters
Type of subaddress, user specified, IA5 characters
Unknown numbering plan
ISDN/Telephony numbering plan (CCITT E.164/E.163)
Data numbering plan (CCITT X.121)
National standard numbering plan
Private numbering plan
Called party subaddress delimiters
or
[[Yn][Nn]called_party_Number][/[Zn]called_party_subaddress/]
AT Command Set Reference