Setup For Windows 95 And Windows Nt 4.0; Selecting The Appropriate Windows 95 Driver (Inf File) - NETGEAR XM128 ISDN Reference Manual

Setup for Windows 95 and Windows NT 4.0

This chapter contains step-by-step procedures both for installing the Windows NT and
Windows 95 drivers and for configuring Dial-Up Networking for the Model XM128 modem.

Selecting the Appropriate Windows 95 Driver (INF file)

If your computer supports the Plug-and-Play feature, be sure your Model XM128 modem is
powered on before starting your computer. If you are using a non-Plug-and-Play protocol, follow
the steps to complete installation:
Open the Control Panel by double-clicking the Control Panel icon in your My Computer
1.
folder.
Double-click on Modems.
2.
Click on Add.
3.
The Install New Modem screen appears.
Select Don't detect my modem; I will select from a list.
4.
Click on Next.
5.
Click on Have Disk.
6.
Insert the NETGEAR Windows 95 driver disk into your floppy drive and click on OK.
7.
If you have downloaded an updated INF file from NETGEAR's Web site or BBS, use
8.
Browse to find the location of the updated INF file, click on Open, then click on OK.
Setup for Windows 95 and Windows NT 4.0
Chapter 3
3-1