Replacing The Batteries (Electronic Flame Control Models); Removal Of The Trim Switch (Electronic Flame Control Models) - Flavel Windsor Installation, Maintenance & User Instructions

4.7.3 Loosen the pilot nut and remove two screw retaining the pilot assembly.
4.7.4 Re-assemble in reverse order and carry out a gas tightness test. Re-fit
coals as shown in section 3. The fender and ash pan cover
can now be re-positioned.
4.8 Replacing the batteries (within the firebox)
4.8.1 Remove the fender and ashpan assembly The battery holder is located
on the right hand side of the appliance .
4.8.2 Remove the battery pack with care and then disconnect the battery lead
at the white rectangular plug and socket.
4.8.3 Replace in reverse order and check correct operation of the appliance.
ENSURE THE BATTERIES ARE CONNECTED TO THE CORRECT POLARITY
POSITVE (+), NEGATIVE (-)
4.9 Removing the trim switch
4.9.1 Remove the burner assembly as in section 4.5 and disconnect the trim
switch cable from the control board.
4.9.2 Remove the 4 off trim switch mounting screws from the front flange of
the firebox.
4.9.3 Remove the trim switch from the frame (trim switch is self adhesive),
4.9.4 Lift the trim switch clear, replace in reverse order and carry out a gas
tightness test.
NOTE : WHEN RE-FITTING THE BURNER PLEASE ENSURE THAT THE
TRIM SWITCH CABLE IS COILED UP AND CORRECTLY REPLACED
BELOW THE HEAT SHIELD. DO NOT LEAVE THE WIRING LOOSE
AS ANY CONTACT WITH THE BURNER WILL CAUSE DAMAGE TO
THE WIRING.
31