Flavel Windsor Installation, Maintenance & User Instructions page 13

For electronic flame control models proceed as follows :-
2.2.3 Remove the two screws at the bottom of the control panel. See figure 6
below.
Fig. 6
2 burner
retaining
screws
2.2.4 The base of the burner unit can now be lifted, lift the two retaining
tabs on the burner brackets from the back of the firebox, allowing
the burner to be removed. See figure 7 below.
Fig. 7
Retaining tabs
on burner
2.2.5 Ensure that the hearth is protected from damage and carefully lift the
fire box into the fire opening, then slide it back into position. Check that
the fire box flange fits flush to the sealing face of the fire surround or
wall with no gaps present.
13