Adjusting The Motion-Control Levers; Pushing The Machine By Hand - Toro Titan MX4800 Operator's Manual

Adjusting the Motion-Control
Levers
Adjusting the Height
Note: Repeat the adjustment for the opposite control lever.
The motion-control levers can be adjusted higher or lower for
maximum operator comfort
A
g027252
Adjusting the Tilt
The motion-control levers can be tilted fore or aft for
maximum operator comfort.
1. Loosen the upper bolt holding the control lever to the
control arm shaft.
2. Loosen the lower bolt just enough to pivot the control
lever fore or aft. Tighten both bolts to secure the
control in the new position.
3. Repeat the adjustment for the opposite control lever.

Pushing the Machine by Hand

Important: Always push the machine by hand. Machine
damage can occur when the machine is towed.
To Push the Machine
1. Park the machine on a level surface and disengage the
blade-control switch.
2. Engage the parking brake.
3. Move the motion-control levers outward to neutral-lock
position, stop the engine, remove the key, and wait for
all moving parts to stop before leaving the operating
position.
4. Locate the bypass levers at the rear of the machine, on
the left and right side of the frame.
5. Move the bypass levers rearward and then down to
lock them in place as shown in
the wheel motors.
(Figure 26).
B
Figure 26
Figure 27 to disengage
Note: Ensure that the left and right bypass levers are
rearward and locked before moving the machine.
6. Disengage the parking brake.
The machine is now able to be pushed by hand.
A
C
To Operate the Machine
Move the bypass to the position for operating the machine
(Figure 27) to engage the wheel motors.
24
B
D
g027642
Figure 27