Stopping The Machine; Adjusting The Height-Of-Cut - Toro Titan MX4800 Operator's Manual

Stopping the Machine

To stop the machine, move the traction control levers
to neutral and move to locked position, disengage the
blade-control switch (PTO), and turn the ignition key to off.
Set the parking brake when you leave the machine; refer to
Operating the Parking Brake (page
the key from the ignition switch
CAUTION
Children or bystanders may be injured if they
move or attempt to operate the machine while it is
unattended.
Always remove the ignition key and set the parking
brake when leaving the machine unattended, even
if just for a few minutes.

Adjusting the Height-of-Cut

The machine is equipped with a foot pedal deck lift system.
The operator can use the foot pedal to lift the deck briefly to
avoid obstacles or lock the deck in the highest height-of-cut
or transport position. The operator can use the height of
cut lever with the foot pedal to lock the deck in a specific
cutting height.
Using the Foot Pedal Deck Lift System
•
Press the pedal down to raise the deck; continue to press
the pedal until the deck is locked in the transport position
(Figure 21).
•
Push on the deck lift pedal with your foot and pull the
transport lock handle rearward to disengage the transport
lock (Figure 21).
17). Remember to remove
(Figure 15).
Transport Lock Position
Adjusting the Height-of-Cut
The height-of-cut can be adjusted from 38 to 114 mm (1-1/2
to 4-1/2 inch) in 6 mm (1/4 inch) increments by relocating
the height-of-cut pin into different hole locations.
1. Push on the deck lift pedal with your foot and raise the
mower deck to the transport lock position (also the
114 mm (4-1/2 inch) cutting height position)
22).
2. To adjust, remove the pin from the height-of-cut
bracket (Figure
3. Select a hole in the height-of-cut system corresponding
to the height-of-cut desired and insert the pin
22).
4. Push on the deck lift pedal with your foot and pull
the handle rearward to disengage the transport lock
(Figure 21).
5. Lower the deck slowly until the lever makes contact
with the pin.
22
g024409
Figure 21
22).
(Figure
(Figure