Installing The Mower Deck; Replacing The Grass Deflector - Toro Titan MX4800 Operator's Manual

Installing the Mower Deck

1. Park the machine on a level surface and disengage the
blade-control switch.
2. Move the motion-control levers outward to the
neutral-lock position, stop the engine, remove the key,
set the parking brake and wait for all moving parts to
stop before leaving the operating position.
3. Slide the mower under the machine.
4. Lower the height-of-cut lever to the lowest position.
5. Place the height-of-cut pin in the lock position for
lowest height-of-cut.
6. Lift the rear of the mower deck and attach the chains
to the rear lift arms
7. Attach the front chains to the front lift arms
69).
8. Install the long, link bar through the frame hanger and
deck.
9. Secure the link bar with the hair pin cotters and washers
removed previously
10. Install the mower belt onto the engine pulley; refer to
Installing the Mower Belt (page
(Figure 69).
(Figure 68).
45).

Replacing the Grass Deflector

Service Interval: Before each use or daily—Inspect the grass
WARNING
An uncovered discharge opening could allow the
lawn mower to throw objects in the operator's or
bystander's direction and result in serious injury.
Also, contact with the blade could occur.
Never operate the lawn mower unless you install a
mulch plate, discharge deflector, or grass collection
system.
Inspect the grass deflector for damage before each use.
Replace any damaged parts before use.
(Figure
1. Disengage the spring from the notch in the deflector
bracket and slide the rod out of the welded deck
brackets, spring, and discharge deflector
2. Remove the damaged or worn discharge deflector.
1. Deflector assembly
2. Deck brackets
3. Rod
3. Position the new discharge deflector assembly with the
bracket ends between the welded brackets on the deck
as shown in
4. Install the spring onto the straight end of the rod.
Position the spring on the rod as shown in so the
shorter spring end is coming from under the rod before
47
deflector for damage.
1
4
3
5
Figure 70
4. Spring
5. Spring installed over the
rod
Figure 70.
(Figure 70).
2
g024317