Removing The Mower - Toro Titan MX4800 Operator's Manual

Figure 67
1. Position the belt cover and
ensure the tabs seat
2. Pivot the belt cover down

Removing the Mower

Park the machine on a level surface and disengage the
blade-control switch. Move the motion-control levers
outward to the neutral position, engage parking brake, stop
the engine, remove the key, and wait for all moving parts to
stop before leaving the operating position.
Lower the mower to the lowest height-of-cut. Select one of
the following procedures depending on the mower deck size
installed to complete the removal.
Preparing to Remove the Mower Deck
1. Lower the mower to the 76 mm (3 inch) height-of-cut
position.
2. Remove the mower belt from the engine pulley; refer
to Removing the Mower Belt (page
Removing the Mower Deck
1. Remove the hair pin cotter and washer securing the
long, link pin to the frame and deck; remove the link
bar (Figure 68).
3. Tighten the screw
45).
1. Link pin
2. Washer
2. Lift up on the mower deck to relieve tension from the
mower deck.
3. Remove the chains from the hooks on the deck lift
arms (Figure 69).
1. Deck lift arm
2. Chain
4. Raise the height-of-cut to the transport position.
5. Remove the belt from clutch on the engine.
6. Slide the mower out from underneath the machine.
Note: Retain all parts for future installation.
46
Figure 68
3. Hair pin cotter
Figure 69
3. Hook
4. Adjustment bolt