Servicing The Fuses - Toro Titan MX4800 Operator's Manual

1. Disengage the blade-control switch (PTO), move the
motion-control levers to the neutral-lock position and
set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. Remove the wing nut securing the battery clamp
(Figure 44).
Figure 44
4. Remove the clamp
5. Disconnect the negative battery cable (black) from the
negative (-)(black) battery terminal
6. Slide the red terminal boot off the positive (red) battery
terminal and remove the positive (+)(red) battery cable
(Figure 44).
7. Remove the battery.
Installing the Battery
1. Position battery in the tray with the terminal posts
opposite from the fuel tank
2. Install the positive (red) battery cable to positive (+)
battery terminal.
3. Install the negative (black) battery cable to the negative
(-) battery terminal.
4. Secure the cables with 2 bolts, 2 washers, and 2 locknuts
(Figure 44).
5. Slide the red terminal boot onto the positive (red)
battery post.
6. Install the clamp and secure it with the wing nut
44).
(Figure 44).
(Figure 44).
(Figure 44).
Charging the Battery
WARNING
Charging the battery produces gasses that can
explode.
Never smoke near the battery, and keep sparks and
flames away from battery.
Important: Always keep the battery fully charged. This
is especially important to prevent battery damage when
the temperature is below 0°C (32°F).
1. Charge the battery for 10 to 15 minutes at 25 to 30
amps or 30 minutes at 10 amps.
2. When the battery is fully charged, unplug the charger
from the electrical outlet, then disconnect the charger
leads from the battery posts
3. Install the battery in the machine and connect the
battery cables, refer to Installing the Battery.
Note: Do not run the machine with the battery
disconnected; electrical damage may occur.
1. Positive battery post
2. Negative battery post

Servicing the Fuses

The electrical system is protected by fuses. It requires
no maintenance; however if a fuse blows, check the
component/circuit for a malfunction or short.
Note: The fuses are located on right hand console next to
the seat (Figure
(Figure
Fuses:
•
Main, 30 amp, blade-type
•
Engine, 20 amp, blade-type
1. To replace the main fuse, grasp the fuse and pull it
straight and away from the fuse block.
36
(Figure
Figure 45
3. Red (+) charger lead
4. Black (-) charger lead
46).
45).