Toro TimeCutter MX 4200 Setup Instructions
  1. Manuals
  2. Brands
  3. Toro Manuals
  4. Lawn Mower
  5. TimeCutter MX 4200
  6. Setup instructions
Toro TimeCutter MX 4200 Setup Instructions

Toro TimeCutter MX 4200 Setup Instructions

Hide thumbs Also See for TimeCutter MX 4200:
1
2
3
4

Advertisement

Table of Contents

TimeCutter
For All TimeCutter

Setup

Loose Parts

Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
Note: Determine the left and right sides of the machine from the normal operating position.
© 2014—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®
Riding Mowers
Description
No parts required
Rear hitch
Bolt (5/16 x 1 inch)
Locknut (5/16 inch)
No parts required
No parts required
No parts required
Ignition key
Hose coupling (not included with CE
models)
Operator's Manual
Engine Operator's Manual
Operator training material
Register at www.Toro.com.
®
Riding Mowers
Qty.
–
1
2
2
–
–
–
1
1
1
1
1
Form No. 3388-201 Rev A
Setup Instructions
Use
Connect the battery.
Install the rear hitch.
Set up the motion-control levers.
Connect the seat-hold bar.
Check the mower adjustment.
Complete the setup.
Original Instructions (EN)
All Rights Reserved *3388-201* A
Printed in the USA.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TimeCutter MX 4200 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Toro TimeCutter MX 4200

Summary of Contents for Toro TimeCutter MX 4200

  • Page 1 Operator's Manual Engine Operator's Manual Operator training material Note: Determine the left and right sides of the machine from the normal operating position. © 2014—The Toro® Company Register at www.Toro.com. Original Instructions (EN) All Rights Reserved *3388-201* A 8111 Lyndale Avenue South Printed in the USA.
  • Page 2 Connecting the Battery Installing the Rear Hitch No Parts Required Parts needed for this procedure: Rear hitch Procedure Bolt (5/16 x 1 inch) Locknut (5/16 inch) WARNING CALIFORNIA Procedure Proposition 65 Warning Battery posts, terminals, and related Install the bracket to the frame as shown in Figure 2 and accessories contain lead and lead compounds, Figure 3.
  • Page 3 Setting Up the Motion-control Levers No Parts Required Procedure 1. Locate the motion-control levers attached, but folded down on the machine. 2. Remove the upper bolt (3/8 x 1 inch) and washer; loosen the lower bolt (3/8 x 1 inch). 3.
  • Page 4 Checking the Mower Completing the Setup Adjustment Parts needed for this procedure: No Parts Required Ignition key Hose coupling (not included with CE models) Procedure Operator's Manual Engine Operator's Manual Adjust the side-to-side level and the front-to-rear blade slope. Use the relevant procedures in the Operator's Manual to verify Operator training material that the deck is level, and make any adjustments as necessary.

Table of Contents