Inspecting The Belts - Toro Titan MX4800 Operator's Manual

1. Blades front to rear
2. Outside cutting edges
Leveling the Mower Deck
1. Set anti-scalp rollers to top holes or remove completely
for this procedure; refer to
Rollers (page 23).
2. Set the height-of-cut lever to the 76 mm (3 inch)
position; refer to Adjusting the Height-of-Cut (page
22).
3. Place two 6.66 cm (2-5/8 inch) blocks under each
side of the front edge of the deck, but not under the
anti-scalp roller brackets
4. Place two 7.30 cm (2-7/8 inch) thick blocks under the
rear edge of the cutting deck skirt; one on each side of
the cutting deck (Figure
1. Wood block, 6.66 cm
(2-5/8 inch) thick
2. Wood block, 7.30 cm
(2-7/8 inch) thick
5. Loosen the adjustment bolts on all four corners so that
the deck is sitting securely on all four blocks
64).
Figure 62
3. Measure from the tip of the
blade to the flat surface
here
Adjusting the Anti-Scalp
(Figure 63).
63).
Figure 63
3. Front edge
1. Deck lift arm
2. Chain
6. Ensure there is tension on all four
7. Tighten the four adjustment
8. Check that blocks fit just snugly under the deck skirt.
Make sure all bolts are tight
9. Verify that the deck is level by checking the side-to-side
level and front-to-rear blade slope; repeat the deck
leveling procedure if necessary.

Inspecting the Belts

Service Interval: Every 50 hours
Check the belts for squealing when the belt is rotating, blades
slipping when cutting grass, frayed belt edges, burn marks and
cracks are signs of a worn mower belt. Replace the mower
belt if any of these conditions is evident.
Note: Lift the floor pan to gain access to the belt and idler
pulley.
(Figure
44
Figure 64
3. Hook
4. Adjustment bolt
chains(Figure
bolts(Figure 64).
64).