Toro Riding Mower Safety - Toro Titan MX4800 Operator's Manual

•
Shut off fuel while storing or transporting. Do not store
fuel near flames or drain indoors.
•
Park the machine on level ground. Set the parking brake.
Never allow untrained personnel to service the machine.
•
Use jack stands to support components when required.
•
Carefully release pressure from components with stored
energy.
•
Disconnect the battery or remove spark-plug wire before
making any repairs. Disconnect the negative terminal first
and the positive last. Reconnect the positive first and
negative last.
•
Use care when checking blades. Wrap the blade(s) or wear
thickly-padded gloves, and use caution when servicing
them. Only replace blades. Never straighten or weld
them.
•
Keep hands and feet away from moving parts. If possible,
do not make adjustments with the engine running.
•
Keep all parts in good working condition and all hardware
tightened. Replace all worn or damaged decals.
Hauling
•
Use care when loading or unloading the machine into a
trailer or truck.
•
Use full width ramps for loading machine into trailer or
truck.
•
Tie the machine down securely using straps, chains, cable,
or ropes. Both front and rear straps should be directed
down and outward from the machine.

Toro Riding Mower Safety

The following list contains safety information specific to Toro
products or other safety information that you must know that
may not be included in the ANSI standards.
•
Use only Toro approved attachments. Warranty may be
voided if used with unapproved attachments.
•
If loading the machine onto a trailer or truck, use a single,
full-width ramp only. The ramp angle should not exceed
15 degrees.
Towing Safety
•
Do not attach towed equipment except at the hitch point.
•
Follow the attachment manufacturer's recommendation
for weight limits for towed equipment and towing on
slopes. Towed weight must not exceed the weight of the
machine, operator, and ballast. Use counterweights or
wheel weights as described in the attachment, or in the
pulling machine Operator's Manual.
•
Never allow children or others in or on towed equipment.
•
On slopes, the weight of the towed equipment may cause
loss of traction, increased risk of rollover, and loss of
control. Reduce the towed weight and slow down.
•
Stopping distance increases with the weight of the towed
load. Travel slowly and allow extra distance to stop.
•
Make wide turns to keep the attachment clear of the
machine.
Service
•
Do not store the machine or a fuel container inside where
there is an open flame, such as near a water heater or
furnace.
•
Keep the nuts and bolts tight, especially the
blade-attachment bolts.
•
Keep the nuts and bolts tight, especially the
blade-attachment bolts.
•
Removing standard original equipment parts and
accessories may alter the warranty, traction, and safety
of the machine. Failure to use original Toro parts could
cause serious injury or death. Making unauthorized
changes to the engine, fuel or venting system, may violate
EPA and CARB regulations.
•
Replace all parts including, but not limited to, tires, belts,
blades, and fuel system components with original Toro
parts.
•
Check the brake operation frequently. Adjust and service
the brake as required.
6