Advertisement
Installation Instructions
Installing the Receiver
The receiver should be located as near as is practical to the
boiler or zone valve to be controlled, as well as a convenient
mains electricity supply. To remove the wall plate from the
receiver, undo the two retaining screws located on the
underside, the wall plate should now be easily removed. Once
the wall plate has been removed from the packaging please
ensure the receiver is re-sealed to prevent damage from dust,
debris etc.
The wall plate should be fitted with the retaining screws located
at the bottom and in a position which allows a total clearance of
at least 50mm around the receiver.
Direct Wall Mounting
Offer the plate to the wall in the position where the receiver is to be mounted and mark the
fixing positions through the slots in the wall plate. Drill and plug the wall, then secure the
plate into position. The slots in the wall plate will compensate for any misalignment of the
fixings.
Wall Box Mounting
The wall plate may be fitted directly on to a single gang flush wiring box complying with
BS4662, using two M3.5 screws. The receiver is suitable for mounting on a flat surface
only; it is not suitable for mounting on an unearthed metal surface.
5
Advertisement
