Advertisement
lnstructions for pairing the SRT322 room thermostat
with the receiver
The SRT322 uses the latest Z-Wave wireless communication technology to give a reliable
wireless link that should not suffer from interference from other nearby devices. The
device comprises of a thermostat and its receiver unit. Pairing the devices on site ensures
reliable communication.
Follow these steps to ensure that the SRT322 thermostat will communicate
satisfactorily with it's receiver, this is best carried out with the SRT322 Thermostat
held nearby the (powered) receiver.
Stage 1
1) Set the number 1 DIL switch on the back of the SRT322
thermostat to the On (Up) position and the display on
the SRT322 will change to show the letter 'I'. If the letter
'L' appears, carry out stage 1A opposite.
2) Power up the receiver unit.
3) The network LED on the receiver should be
flashing.
4) Press the dial on the front of the SRT322
thermostat once so that the 'I' in the display flashes.
5) Press and hold the network button on the receiver
until the On indicator flashes (green) before the Off
indicator becomes solid red.
6) After a few seconds the radio mast symbol
appear in the display along with the letters IP.
7) Reset the number 1 DIL switch on the back of the
SRT322 to the Off position and the temperature
should return in the display.
8) Now check the receiver responds to the thermostat on and off commands by
increasing and decreasing the temperature settings until it switches accordingly.
N.B. There is a half second delay in switching On and Off on receipt of the command.
9) The Z-Wave communication link is now successfully established.
10
SWITCH CONFIGURATION SRT322
will
Network LED
ON
OFF
TPI
3
TPI
6
TPI
12
Network button
Advertisement
