Secure SRT322 User And Installation Instructions Manual page 11

Battery powered wireless digital electronic room thermostat with receiver

Under normal circumstances the SRT322 thermostat and receiver will be 'paired'

easily by following the procedure shown under Stage 1 of the pairing instructions.

Only use Stage 2 if a radio link cannot be successfully established between the two

devices.

Stage 1A – Only used if 'L' is displayed instead of 'I'

1) Turn the dial of the SRT322 until the letter P appears in the display.

2) Press the dial twice.

3) A second P should appear in the display which now shows `PP'.

4) Turn the dial until the letter 'I' appears in the display and return to the main

instruction.

Stage 2 – Only used if the above procedure does not establish

a successful communication link

1) Turn the dial until the letter P appears in the display.

2) Press the dial twice and PP should appear in the display.

3) Now turn the dial until letter E appears in the display.

4) Press the dial once and the display should flash.

5) Press and hold the network button on the receiver until it starts to flash.

6) Turn the dial until the letter `I' appears in the display and return to the main

instruction.

Table of Contents