Fasteners And Torque Settings - InFocus LP500 Service Manual

Fasteners and Torque Settings

Below is a list of the fasteners included in the fastener kit (802-0027-xx) for the LP500 and LP530
projectors. You'll also find the suggested torque settings for each fastener.
Fastener
Jack nut 4-40 w/lock
M1.8x8 Phillips Plastite Interlock switch to lamp housing (1)
M2.5x6 Black Torx
Plastite
M3x6 Torx
M3x6 Torx, Black
Plastite
M3x8 Torx with
shoulder washer
M3x8 Black Torx
M3x8 Torx Plastite
M3x8 Black Torx
Plastite
M3x10 Torx
M3x12 Torx Plastite
M3x14 Philips Pan
Head
M3x48 Black Torx
LP500 Series Service Manual
Application
I/O EMI shield to controller ECA (2)
Leveling foot (1)
Ground clip to chassis (1), diode heat sink bracket to
chassis (1)
Speaker to speaker bracket (2), Keypad to top case
(2), IR ECA to top case (1)
Power supply (6) to chassis, optical engine to bottom
case (3), rear bezel to chassis (2), chassis to engine
(2), lamp connector to lamp housing (2), controller
ECA (8), speaker bracket to chassis (1), lamp housing
to engine (1)
Front bezel (2)
Chassis to bottom case (2), engine mount bracket to
bottom case (1), lamp blower (1), optical engine to
bottom case (3)
Front bezel vent (1)
Power supply fan to chassis (2)
Lamp fan (2)
Front fan to optical engine (2)
Top case to bottom case (2)
Torque
2 in.-lbs. (.226 Nm)
4 in.-lbs. (.452 Nm)
4 in.-lbs. (.452 Nm)
6 in.-lbs. (.68 Nm)
4 in.-lbs. (.452 Nm)
Lamp connector: 4 in.-
lbs. (.452 Nm)
Others: 6 in.-lbs. (.68
Nm)
4 in.-lbs. (.452 Nm)
6 in.-lbs. (.452 Nm)
4 in.-lbs. (.452 Nm)
6 in.-lbs. (.68 Nm)
6 in.-lbs. (.68 Nm)
6 in.-lbs. (.68 Nm)
4 in.-lbs. (.452 Nm)
119