InFocus LP500 Tech Note

Cleaning the lamp module dust filter screens

Hide thumbs Also See for LP500:

Cleaning the lamp module dust filter screens

In dirty or dusty environments, the lamp module dust filter screens can become plugged, causing

excessively high temperatures inside the lamp module. Excessively high temperatures can cause

premature lamp failure. Routine maintenance to remove dust and dirt from the filter screens lowers the

lamp operating temperature and lengthens lamp life.

This Tech Note describes how to clean the lamp module dust filter screens. Clean them every 200-250

hours when the projector is used in areas with high levels of airborne contaminants such as lint, dust or

smoke.

To remove the lamp door, press the lip on the outside edge of the door until the door slides

inward. Then swing the door open.

Loosen the two captive screws that secure the lamp to the lamp housing.

Swing the bail on the top of the lamp module up, then pull the module out of the projector.

Table of Contents

Do you have a question about the LP500 and is the answer not in the manual?

Page 1 This Tech Note describes how to clean the lamp module dust filter screens. Clean them every 200-250 hours when the projector is used in areas with high levels of airborne contaminants such as lint, dust or smoke.
Page 2 Use compressed or canned air to clean the screens on both sides of the lamp housing. Then use a cotton swab dipped in isopropyl alcohol to lightly wipe each screen. When you've wiped each screen, use the compressed or canned air to blow away remaining contaminants. LP500/LP530 Lamp Maintenance...
Page 3 Before you replace the lamp, use the compressed or canned air to clean the lamp housing inside the projector. Replace the lamp and lamp door. LP500/LP530 Lamp Maintenance...

Lp530