Frus By Numeric Listing - InFocus LP500 Service Manual

FRUs by numeric listing

Below is a numerically arranged list of FRUs used in the LP500 and LP530 projectors. You can also view
FRUs by alphabetic listing (see page 113).
Part Number
020-1102-xx
020-1112-xx
020-1136-xx
020-1137-xx
206-0032-xx
211-0161-xx
211-0162-xx
321-0170-xx
328-0029-xx
329-0251-xx
329-0268-xx
329-0276-xx
329-0299-xx
329-0301-xx
329-0302-xx
329-0306-xx
329-0337-xx
330-0702-xx
330-0703-xx
330-0724-xx
330-0742-xx
LP500 Series Service Manual
Part Name Projector
Certification label LP530
InFocus nameplate Both
label
Certification label LP500
Rear bezel label Both
Thermal switch clip Both
Controller/power Both
supply cable
Interlock switch Both
cable
Elevator spring Both
Rubber foot Both
PSA square Both
Power supply Both
insulator
Speaker gasket Both
Lamp blower Both
gasket
Gap pad, rear Both
diode
Gap pad, front Both
diode
Lamp fan heat Both
shield
Lamp blower heat Both
shield
Chassis Both
I/O EMI shield Both
Ground clip Both
Diode heat sink Both
bracket
Notes
Fastens the thermal switch to the lamp
housing.
Connects the interlock switch assembly
with the power supply.
Required for new lamp blower
Fits between the power supply and
chassis.
Required when replacing speaker.
Adheres to the diode heat sink bracket
(330-0742-xx).
Adheres to the chassis.
Required for new lamp fan.
Required for new lamp blower.
Fastens to the chassis. Grounds to the
optical engine.
Also requires rear gap pad (329-0301-xx).
Fits between the chassis and the bottom
of the power supply.
116