Using The Keypad To Power Up The Projector - InFocus LP500 Service Manual
Hide thumbs
Also See for LP500:
- User manual (79 pages) ,
- Driver installation (6 pages) ,
- Brochure (4 pages)
Table of Contents
Advertisement
Using the keypad to power up the projector
If you don't have a remote to start the projector with its top removed, you can use the keypad.
1
Remove the keypad from the inside of the top cover. To do this, remove the two M3x6 black
Plastite Torx screws, then lift the keypad out of the top case.
2
Plug the keypad cable into the ZIF connector on the controller ECA.
LP500 Series Service Manual
110
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
