InFocus LP500 Service Manual page 21

Assembly Notes
♦
If you're replacing the top case with a new one, install the keypad on the inside of the case (see page
22).
♦
Adhere a new InFocus nameplate to the top case in the recess near the IR window.
♦
Connect the keypad and IR cables first. Then engage the hinges on the lens side of the projector.
♦
Swing the top case shut, making sure that it fits flush over the bottom case.
♦
Torque the black M3x48 cone point Torx screw to 4 in.-lbs. (.452 Nm)
LP500 Series Service Manual 21