Table of Contents
Advertisement
Controlling your presentations
Connect the USB cable between your computer and the projector's DisplayLink connector
(see step
), then press
3
Note: You don't need to install DisplayLink Manager software to use this feature.
Use LitePort source
6
Turn off the projector
7
READ THE REFERENCE GUIDE
Download it at
The Reference Guide is available in multiple languages. It covers advanced setup and
All manuals and user guides at all-guides.com
Using the menus
1
Press menu, then press
2
Press select to enter a menu, then press
3
Press select to change a setting. If this shows more choices, press
or
to update the setting, then press select or menu to save it.
4
Press menu to go back. Press it again to remove the menu.
Note: Most picture settings are disabled (gray) unless a source is being displayed.
and
to move through your presentation slides.
View photos from a USB flash drive
Copy JPEG pictures to a USB flash drive, then plug the drive
into the projector's LitePort connector. The slideshow starts
automatically. Press arrow keys to change slides, press select
to see thumbnails and change folders, press select again to
return to the slideshow.
Press the power button
The power light on the projector will blink while the fan cools
the lamp. If you need to unplug the projector, wait until the
fan stops and the power light stops blinking and stays on.
Note: While the power light is blinking, button presses on the
projector and remote are ignored.
www.infocus.com/support
operation, including lamp replacement instructions.
or
to review menus.
or
(IN1503 only)
to review settings.
Advertisement
Table of Contents
