When Not Using For A Long Term (Custody Wash) (Firmware Ver.3.20 Or Older) - MIMAKI JV33-130BS Operation Manual

When not using for a long term (CUSTODY WASH) (firmware Ver.3.20 or older)

When the operation of the machine is to be suspended for a week or more, use the [CUSTODY WASH]
function to clean the nozzles in the heads and the ink discharge passage.
After the cleaning, store the machine properly.
This function is available for the firmware Ver. 3.20 or earlier.
Check the follow-
ings in advance.
• When the following messages are indicated, check the waste ink tank, and then operate it,
referring to P.4-40 "If Waste ink tank confirming message is displayed" according to the situa-
tion.
1
Press the
mode.
2
Select [CUSTODY WASH] by pressing
the
3
Press the
• The carriage moves onto the platen.
4
Clean the wiper and the bracket.
(1) Open the front cover then pull out it by holding projections at both ends of the wiper.
(2) Clean it with a clean stick dipped in the cleaning solution.
(BS ink : SPC-0563)
(3) Insert it in the original position by holding the projections at both ends of the wiper.
4-14
Is [NEAR END] or [NEAR END] displayed ?
• The cleaning solution or ink is absorbed in washing.
At this time, washing is unable to operate if the ink end or near-end is
detected.
• Replace it with a cartridge undetected for the ink end or the like.
C o n f i r m a w a s t e t a n k
C o n t i n u e < > E x c h a n g e
key in the local
keys.
key.
C o n f i r m a w a s t e t a n k
E x c h a n g e : e
S T . MA I N T ENANCE
CARR I AGE OU T
S T . MA I N T ENANCE
CUS TODY WA SH
W I P ER C L E AN I NG
COMP L E T ED ( NE X T )
n t
< e n t >
< e n t >
: e n t
Projection