Table of Contents
Advertisement
Install indoor unit
1. Always mount the rear panel horizontally. As the water drainage pipe at the left, when
adjusting the rear panel, this side should not be too high; the right side should be slightly high.
2.Fix the rear panel on the selected
location.
3.Be sure that the rear panel has
been fixed firm enough to withstand
the weight of an adult of 60kg,
furthermore, the weight should be
evenly shared by each screw.
1． Make the piping hole（φ 55） in the wall at a slight downward
slant to the outdoor side. At Fig.6.
2． Insert the piping-hole sleeve into the hole to prevent the connection piping
and wiring from being damaged when passing through the hole.
For well draining, the drain pipe should be
1．
placed at a downward slant.
Do not wrench or bend the drain pipe or flood
2．
its end by water.
When the long drainage pipe passing through
3．
indoor, wrap it with insulation materials.
1. Open the front panel, to disassemble the screw cap ,
take off the filter,to screw off the screws on the on
front case (4 screws).
2. Put the power connection cable through the back of
indoor unit wire hole and take it out.
3. Connect the blue wire of power connection cord to
the terminal on "N", the black one to "2",the brown
one to "3", the yellow-green one (earth wire) to
"
" (As shown in Fig. 7)
4. Put the power connection cable the
sheath into wire groove, screw on the fixing
tighten the connection wire.
5. Install the front case, tighten the screws (4pcs),
install the filter,cover the front panel cover .
6. For the cooling and heating unit, signal control
wire can be passed through the connection of
connector and indoor unit, and use the wire clip
that is under the body case, tighten the signal
control wire (As show in Fig. 8)
Install the rear panel
Wall
Space to
the wall
150mm
above
Left
φ55mm
(Rear piping hole)
Install the piping hole
Install the water drainage pipe
Electrical wiring
section,that with
screw,
Mark on the middle of it
Fig.6
Wrenched
Wire in unit
Signal control
Connector
wire
(4X0.75)
Wire clamp
Fig.8
20
Gradienter
Space to
the wall
150mm
φ55mm
(Rear piping hole)
Indoor
Outdoor
Wall pipe
Protection
sleeve pipe
Bent
Flooded
Terminal board
Blue
Black
Yellow-green
Power connection wire
Fig.7
Wall
above
Right
Seal pad
Ø
55
Brown
Advertisement
Table of Contents
