Table of Contents
Advertisement
The unit installation work must be done by qualified personnel according to the local
１．
rules and this manual.
Before installating, please contact with local authorized maintenance center, if unit is
not installed by the authorized maintenance center, the malfunction may not solved,
due to discommodious contacts.
When removing the unit to the other place, please firstly contact with the authorized
Maintenance Center in the local area.
Install in the following place may cause malfunction. If it is unavoidable,please
contact with service center please:
Place where strong heat sources, vapors, flammable gas or volatile objuct are emitted.
Place where high-frequency waves are generated by radio equipment, welders and
medical equipment.
Place where a lot of salinities such as coast exists.
Place where the oil (machine oil) is contained in the air.
Place where a sulfured gas such as the hot spring zones is generated.
Other place with special circumstance.
The air intake and outlet vent should be far from the obstruction, make sure that the air
can be blown through the whole room.
Select a position where the condensing water can be easily drained out, and the place
is easily connected for outdoor unit.
Select a location where children can not reach.
Select the place where is strong enough to withstand the full weight and vibration of
the unit. And will not increase the noise.
Be sure to leave enough space to allow access for routine maintenance. The height of the
installed location should be 200cm or more from the floor.
Select a place about 1m or more away from TVset or any other electric appliances.
Select a place where the filter can be easily taken out.
Make sure that the indoor unit installation should accord with installation dimension
diagram requirements.(on page 19)
Select a location from which noise and outflow air emitted by unit will not inconvenience
neighbors, animals, plants.
Select a location where there should be sufficient ventilation.
Select a location where there should be no obstructions cover the inlet and outlet vent.
The location should be able to withstand the full weight and vibration of the outdoor unit
and permit safe installation.
Select a dry place, but do not expose under the direct sunlight or strong wind.
Make sure that the outdoor unit installation dimension should accord with installation
dimension diagram, convenient for maintenance, repair.(
The height difference of connecting the tubing should within 5m, the length of connecting the
７
tubing should within 10m.
Select a place where it is out of reach for the children.
８
Select a place where will not block the passage and do not influence the city appearance.
９
１
The power supply should be used the rated voltage and AC exclusive circuit,
the power cable diameter should be satisfied.
２
Voltage applying range: the normal running range is rated voltage 90%-110%.
Don't drag the power cable emphatically.
３
Installation service- Notices for installation
Important Notices
Basic Requirements For Installation Position
Indoor Unit Installation Position Selection
Outdoor Unit Installation Position Selection
Safety Requirements For Electric Appliances
１７
on page 19)
Advertisement
Table of Contents
