Install The Indoor Unit; Install The Connection Pipe - Gree GWCN1407X2B8NK1BA Owner's Manual

Hide thumbs

Table Of Contents

Table of Contents

NOTE:

When connecting the electric wire if the wire length is not enough, please contact with

the authorized service shop to buy an exclusive electric wire that is long enough.Setting

joint on the wire are not allowed.

The electric wiring must be correctly connected, wrong connection may cause spare

●

parts malfunction.

Tighten the terminal screw in order to prevent loose.

●

After tighten the screw, slightly pull the wire and confirm whether it is firm.

●

If the earth wire is wrong connection, that may cause electric shock.

●

The piping can be led out from right, right rear,

●

left, left rear.

When routing the piping and wiring from the left

１．

or right side of indoor unit, cut off the tailings

from the chassis in necessary (show in Fig.9).

Cut off the tailings 1 when routing the wiring only;

⑴　

Cut off the tailings 1 and tailings 2 when routing

⑵

both the wiring and piping.

Take out the piping from body case, wrap the piping

２．

electric wire, water pipe with tape and put them th-

rough the piping hole (As show in Fig.10)

Hang the mounting slots of the indoor unit on the

３．

upper tabs of the rear panel and check if it is firm

enough. (As show in Fig.11)

The height of the installed location should be 2m

４．

or more from the floor.

１．

Align the center of the piping flare with the

relevant valve.

Screw in the flare nut by hand and then tighten

２．

the nut with spanner and torque wrench.Refer

to the following.

Tightening torque table

Hex nut diameter

９．５

１２

NOTE: Firstly connect the connection pipe to indoor unit first then to outdoor unit; pay attention

to the piping bending, do not damage the connection pipe; and the joint nut couldn't tighten

too much, otherwise it may cause leakage.