Table of Contents
Advertisement
Operation of wireless remote control
★
About the Super Strong function
When the Super Strong function is turned on, the whole unit runs at the high fan speed, and runs at the
Quick COOL or Quick HEAT operation, to make the ambient temperature swiftly approach to the setting
temperature. Turn off the Super Strong function, the whole unit runs at the setting fan speed.
★
About LOCK
Press + and - button, can lock or unlock the keyboard, after locked, the symbol of the lock
at this time, to press any key, the symbol will flash for 3 times. After it is unlocked, the symbol will disappear.
Slightly press the place with
control. (As show in figure)
２
Take out the old batteries. (As show in figure)
３．
Insert two new AAA1.5V dry batteries, and pay attention to the polarity.
(As show in figure)
４
Attach the back cover of wireless remote control. (As show in figure)
★
NOTE:
●
When changing the batteries, do not use the old or different batteries,
otherwise, it can cause the malfunction of the wireless remote control.
If the wireless remote control will not be used for a long time, please
●
take them out, and don't let the leakage liquid damage the wireless
remote control.
●
The operation should be in its receiving range.
●
It should be placed at where is 1m away from the TV set or stereo sound sets.
●
If the wireless remote control cannot operate normally, please take them out,
after 30s later and reinsert, if they cannot normally run, please change them.
●
When it is needed to control the main unit, please aim at the receiving device, in order to improve the sensitivity
of the main unit. When the wireless remote control is sending information,
main unit is receiving the information, it will emit a sound.
When the wireless remote control is lost or damaged, please use
the manual switch. At this time, it is running in Auto Run mode,
and will not change the temperature setting value and fan speed.
Adopt the following operation by using ball point pen or some
insulators:
Turn on the unit: At unit off, press the manual switch, the unit will
●
enter into AUTO running state automatically. The microcomputer
will select COOL, HEAT, FAN according to the indoor temperature
to achieve the comfortable efficiency.
Turn off the unit: When unit is running, press the manual switch STOP button, the unit will stop running.
●
Changing batteries and notices
, along the arrowhead direction to push the back cover of wireless remote
Emergency running
１１
will be displayed
Sketch map for changing batteries
the symbol will flash 1s. When
AUTO
TEST
RUN
STOP
Manual switch
Fig. 3
Fig. 1
Fig. 2
Advertisement
Table of Contents
