VESPA GT 200 Workshop Manual page 59

Vespa GT 125-200
- Check that the SAS valve plastic support is not
dented or distorted
- Check that the gasket is in good conditions
- Carefully clean the inside and outside filters. Re-
place them if damaged or abnormally distorted.
- Make sure the coupling connecting the secon-
dary air to the head is not dented, overheated or
distorted. If there is, replace it.
- Check that the metal pipe does not have any
dents
CAUTION
INADEQUATE TIGHTNESS BETWEEN THE SAS VALVE
AND ITS SUPPORT INCREASES NOISE IN THE SAS SYS-
TEM.
To refit, follow the removal procedure in reverse order being careful to respect the direction of the rubber
coupling connecting the SAS valve and the discharge system
Downloaded from www.Manualslib.com manuals search engine
Maintenance
MAIN - 59