VESPA GT 200 Workshop Manual page 212

Suspensions
Length of the swinging arm tube on the frame
side:
283 ± 0.1 mm
- Lubricate roller casings and the plastic bushings
with grease
- Insert the spacers
- Assemble the two arms with the relative bolt in
the position shown in the photograph
- Adjust the bolt as shown in the photograph
- Position the frame side swinging arm with the
most protruding part pointing towards the silent
block side as shown in the photograph
Recommended products
AGIP GREASE PV2 Grease for the steering
bearings, pin seats and swinging arm
Soap-based lithium and zinc oxide grease con-
taining NLGI 2; ISO-L-XBCIB2 of the swinging arm
- Make sure the silent bloc is not broken. If there
is, replace it.
- Remove the seeger ring shown in the photograph
- Remove the full silent bloc bracket
- Undo the silent bloc ring shown in the photograph
SUSP - 212
Downloaded from www.Manualslib.com manuals search engine
Vespa GT 125-200