VESPA GT 200 Workshop Manual page 196

Suspensions
- Remove the oil seal on the roller bearing side
using a screwdriver.
- Remove the roller bearing using the specific tool
Specific tooling
020376Y Adaptor handle
020456Y Ø 24 mm adaptor
020363Y 20 mm guide
- Heat the roller bearing seat with a heat gun
- Use the specific tool to introduce and push the
bearing until it stops, with the shielded side facing
out
- Refit the ball bearing check seeger ring
Specific tooling
020151Y Air heater
020376Y Adaptor handle
020359Y 42x47-mm adaptor
020412Y 15 mm guide
- Use the specific tool to fit and push the roller cas-
ing until it stops
- Refit the oil seal on the roller bearing side
- Lubricate the area between the roller bearing and
the ball bearing
Specific tooling
020038Y Punch
Recommended products
AGIP GREASE MU3 Grease for odometer
transmission gear case
SUSP - 196
Downloaded from www.Manualslib.com manuals search engine
Vespa GT 125-200