VESPA GT 200 Workshop Manual page 203

Vespa GT 125-200
4 on the stem, on the side opposite the one shown
in the figure to refit the second wedging washer -
roller casing - sealing ring unit.
To position roller casings on the pin (pin end in
contact with the internal bottom of the roller cas-
ings) proceed as follows:
- Use the tool with part 20 and 21 fitted to the stem
as indicated in the figure.
- Push the two roller casings with the handgrip until
their bottoms make contact with the pin end.
- Use the specific tool fitted with parts 3 and 4 as
indicated for fitting the spin and push with the
handgrip until the washer is wedged in the swing-
ing hub.
- Remove the spacers, part 17; fill with recommen-
ded grease the area between the steering tube
and the swinging hub, and place the dust guard
rings in that place.
Recommended products
AGIP GREASE PV2 Grease for the steering
bearings, pin seats and swinging arm
Soap-based lithium and zinc oxide grease con-
taining NLGI 2; ISO-L-XBCIB2 of the swinging arm
Carry out this operation only if strictly necessary and in any case remove and replace the old part with
a new one.
- Remove the steering tube
- Use a special tool remove the upper disk of the
fifth wheel fitting seat on the headstock by operat-
ing form the lower part of the headstock as indica-
ted in the photograph. Afterwards remove the
lower disk of the fifth wheel operating from the up-
per part
Specific tooling
020004Y Punch for removing fifth wheels from
headstock
Downloaded from www.Manualslib.com manuals search engine
Suspensions
SUSP - 203