VESPA GT 200 Workshop Manual page 199

Vespa GT 125-200
Suspensions
- Pre-loosen the 3 nuts fixing the mudguard to the
suspension
- Remove the rear handlebar cover.
- Remove the screw fixing the handlebar to the
steering tube
- Tilt the handlebar towards the shield back plate
being careful not to scratch the plastic parts
- Remove the steering tube ring nut cover
- Use a specific tool to remove the counter-ring nut,
the spacer washer and the ring nut of the upper
disk of the fifth wheel fitting
- Slide off the steering tube and remove perma-
nently the mudguard from the suspension
Specific tooling
020055Y Wrench for steering tube ring nut
SUSP - 199
Downloaded from www.Manualslib.com manuals search engine