Connecting Ethernet Port; Connecting Vdsl Ports - Dynamix DV-24 User Manual

Connecting Ethernet Port

Ethernet Port "25" and "26" support auto MDI/MDIX.
You can connect the "25 or 26" port on the IP DSLAM to any device that uses a standard network interface such as a
Cable modem, ADSL modem, Ethernet Switch, workstation or server, or also to a network interconnection device
such as a bridge or router (depending on the port type implemented).
Prepare straight through (or cross over) shielded or unshielded twisted-pair cables with RJ-45 plugs on both ends.
Use 100Ω Category 5 cable for connections. Connect one end of the cable to "25" port of the IP DSLAM, and the
other end to a standard RJ-45 station port on cable modem, ADSL router, wireless bridge, etc. When inserting an
RJ-45 plug, be sure the tab on the plug clicks into position to ensure that it is properly seated.
Notes: Make sure the length of twisted-pair cable is not over 100 meters (328 feet).

Connecting VDSL Ports

1. Prepare the network devices you wish to connect. Make sure you have installed suitable VDSL Modem before
making a connection to any of the IP DSLAM (1-24) station ports. You also need to prepare one 18 ~ 26 gauge
twisted pair phone Line wiring with RJ-21 plugs at both ends.
2. Connect one end of the cable to the RJ-21 port of the Home Access network adapter, and the other end to any
available (1~24) station port on the VDSL. Every port supports 5/15/25 Mbps connections. When inserting an
RJ-21 plug, be sure the tab on the plug clicks into position to ensure that it is properly seated.
• Instead, use only twisted-pair cables with RJ-45 connectors that conform the FCC standards.
24VDSL+2Giga Ethernet Managed 4 Band VDSL IP DSLAM USER'S MANUAL Ver. A.4
13