Possible Adjustments - Vermeiren Squod Instruction Manual

3.3

Possible adjustments

L L L L
WARNING:
Risk of injury - Turn the electric wheelchair off before you perform any
adjustments.
L L L L
WARNING:
Risk of injury - Never perform any adjustments while you are driving.
L L L L
WARNING:
Risk of injury - Adjustments may only performed by your specialist
dealer.
L L L L
WARNING:
Risk of injury - Make sure all screws, levers are firmly secured
before driving with your electric wheelchair.
L L L L
CAUTION: Risk of clamping – Keep fingers, buckles and clothes away from the
attachment points or any moving parts.
3.3.1 Adjusting seat angle
L L L L
WARNING:
Risk of injury - Check that the seat attachment is between the
bushings.
L L L L
WARNING:
Risk of injury - Check that the seat is firmly attached.
The seat angle (0° - 9° ) can be adjusted according following steps:
Detail B
1. Remove the seat
2. Remove the screw
.
3. Place the seat hooks
the desired position (refer table 2 and detail
Detail A
A).
Hole Ⓐ
0°
Hole Ⓒ
1,6°
Hole Ⓓ
3,2°
Hole Ⓔ
4,8°
Hole Ⓕ
6,4°
Hole Ⓖ
4. To fit the seat hooks
the seat frame, you can rotate these
around the screw (see detail B).
Page 24
from the seat frame.
from the seat hook
on both sides in
Hole Ⓑ
2,6°
Hole Ⓒ
4,2°
Hole Ⓓ
5,8°
Hole Ⓔ
7,4°
Hole Ⓕ
9°
Hole Ⓖ
Table 2: Seat angles
on the tubes from
Squod
2013-09