Table of Contents
Advertisement
3.3.2 Adjusting the arm supports
The width of the arm supports can be adjusted in horizontal direction.
3.3.3 Adjusting the footrests
L L L L
CAUTION:
Risk of damage – Avoid that the footrests make any contact with the
ground. Keep a minimum distance from 60 mm above the ground.
* Adjusting length:
1. Loosen the hexagon socket set screws
just under the seat frame.
2. Move the arm support in an horizontal
direction until the correct position, by
moving the rectangular tubes
over each other. (Range 60 mm: step less)
3. Retighten the screws
4. Repeat instructions above for the other arm
support.
Check that the arm supports are
positioned identically on both sides.
Adjust the length of the footrests as follow:
1.
Loosen the screw
2.
Adjust the length of the footrest to a
comfortable length.
(3 positions possible: steps 35 mm →
holes outside tube, 3 positions possible:
steps 25 mm → inner tube)
3.
Tighten the screw
Check that the footrests are positioned
identically on both sides.
Page 25
Squod
2013-09
and
properly.
.
properly.
Advertisement
Table of Contents
