Table of Contents
Advertisement
Next, connect the charger cable with the three-pin plug to the loader socket on the electric
wheelchair's operator unit. Once connected to the batteries, the charger automatically begins
charging. Now only the yellow LED is active.
When charging is complete, the yellow LED goes out and the green LED comes on. Now
remove the charger cable from the operator unit. The charger switches back to STAND-BY
mode (yellow and green LEDs active).
If the charger cable is not removed, a tiny current will keep the batteries topped up (trickle
charging).
If you decide not to use your electric wheelchair for an appreciable period, you must
nevertheless recharge it regularly to keep it in a running condition ready for immediate use.
The manufacturer accepts no liability for damage caused by improper charging.
For further information, please refer to the user instructions provided with the charger.
2.22 Backrest inclination
L L L L
CAUTION:
Risk of injury - Tighten the parking brakes, if available before adjusting
the backrest.
L L L L
CAUTION:
Risk of tipping over - Be aware that the stability decrease when you
adjust the backrest backwards.
L L L L
CAUTION:
Risk of tipping over - Place the backrest in the most vertical position
when driving the wheelchair on ramps. Now the wheelchair has the best
backwards stability.
The inclination of the backrest from the
electric wheelchair is over a range from -90°
to +35° (steps from 11° ).
1. Turn on the levers
2. Grasp the handgrips
3. Push or pull the backrest tubes
front or backwards to the desired
inclination. Max inclination is that the
backrest tubes
4. Retighten the levers
Page 22
Squod
2013-09
until they come loose.
.
to the
rest on the pens
.
properly by hand.
Advertisement
Table of Contents
