Operating The Electromagnetic Brakes - Vermeiren Squod Instruction Manual

2.12.2 Handling after usage
Before getting off from your electric wheelchair, make sure that all four wheels touch the
ground simultaneously.
Push on the "ON/OFF" button from the operator unit, the display of the operator unit goes
out.

2.13 Operating the electromagnetic brakes

Let go of the joystick to stop the electric wheelchair.
2.13.1 Parking the electric wheelchair
Once your electric wheelchair has been turned off, no command can be sent to the driving
system. Always park your electric wheelchair on sites that are easy accessible and on
horizontal surfaces that the four wheels are touching the ground.
2.13.2 Operator units
* Shark controller
The instructions for use from the operator units you can find in the seperate user manals of
the operator units that is included with your wheelchair.
Changing the software is only allowed by Vermeiren. For changes in the software
contact Vermeiren.
2.13.3 Adjusting operator unit
L L L L
CAUTION:
Risk of pinching - Do not put your fingers between the operator
control and the other parts when positioning the operator unit.
The operator units horizontal position can be changed:
1. Loosen screw just under the armpads a little bit.
2. Move the operator unit to the desired position or remove the operator unit.
3. Retighten screw
If you pull screw to the side, the operator unit can be turned to the side.
NOTE: Depending on the features of your wheelchair, screw
beneath the guide tube ➁ .
2
properly.
1
Page 15
Squod
2013-09
could also be located