HeliArtist atrwolf Instruction Manual page 6

13
Disassemble the tail gear box of the Heli mechanism then
insert the Heli Body into the fuselage.
15
Assemble the Tail Cover back to the fuselage.
17
Assemble the Vertical stabilizer to the fuselage's tail using
two 3x20mm Self-Tapping Screws.
14
Assemble the tail gear box back to the Heli Mechanism.
16
Align the Heli Body to the fuselage and drill four 3mm
holes on the bottom side. Use M3x25mm screws and
washers to secure the Heli Body to the fuselage.
18
Fit the Horizontal stabilizers onto the trough on the Tail
Boom of the fuselage and use epoxy to secure them.
(Remarks: make sure the Horizontal stabilizers are in
perpendicular condition.)
6