Advertisement
7
Tighten the Back Retract Systems onto the Carbon Rods
together with two Lock Ring on each side of Retract
System. (Used Parts: ￠ 5mmLock Ring x4,Carbon Rods ￠
5x110mm x2 and M3 Set Screws x2. ）
9
After assembled the Heli body to the fuselage then glue
the Wood Servo Mount onto the fuseages using epoxyand
tighten the Linkage Ball on the Servo Horn.
11
Align and glue the Wood Blocks to the landing gear
position on the Heli Body.
8
Tighten the Lock Rings on the two end of the Front
Retract System Carbon Rod then Insert the Wheel Control
Arms next to the Lock Ring End and secure them with
gule and M3 Set Screws. (Used Parts: Screw M2x10mm
x4, ￠ 4mmLock Ring x2, M3Set Screw x2 ）
10
Glue the wood together according to the above photo.
(Remarks: the hight of the wood block is depend on what
heli you use.)
12
Disassemble the Tail Cover from the tail of the fuselage.
5
Advertisement
