Advertisement
1
Tighten the Ball Links with Linkage Ball to the Wheel
Control Arm, caution the assembly direction.(Use
M3x10mm Screws x4)
3
Assemble the Front CNC Retract System using 4x100mm
Carbon Rod and two Retract system stands.
5
Use M3x10mm screws x4 with M3 Nuts to tighten the Front
Retract System onto the fuselage body.
2
Twist the Ball Links from Step 1. onto the Linkage Rods.
(Caution the assembly direction.)
4
Put the Front Retract System into the fuselage body and
align the screw holes of Retract System Stands to the
holes on the bottom of the fuselage body.
6
Insert the 4x55mm Carbon Rods into the specific position
of the Gun Housing and secure it with glue. (This is used to
prevent further retraction of the Retract System.)
4
Advertisement
