Description; Starting Up; Electrical Connection - Alto SQ 691-9M/B1 Operating Instructions Manual

The cleaner may not be
used if ignition sources (BIA
B1, para 4.2) can not be
excluded for certain when
it is used on running pro-
cessing machines (object
extraction) or if there is a
risk that effective ignition
sources are also sucked in.
For safety reasons, the
cleaner is not suitable for
collecting explosives or
equivalent materials in the
sense of para 1 of the Ex-
plosives Act, inflammable
fluids and mixtures of
inflammable dusts with
fluids. If the above safety
restrictions are not ob-
served, the utilisation of the
cleaner in this case is
considered to be an im-
proper use.
Also considered to be an
improper use
employing the SQ 691-
9M/B1 to collect burned
propellant charge powder
from conductive collecting
devices (eg exhaust hoods)
or from other conductive
parts of the installation at
the firing stand - except
that the respective parts of
the installation
grounded via the cleaner
itself or otherwise to
prevent electrostatic
charges.
DESCRIPTION (Fig. 1)
1 Collecting tank
2 Clip
3 Suction regulator
4 On-off switch
5 Handle
6 Inlet fitting
7 Plug
8 Tank grip
The cleaner may only be
operated with the attach-
ments supplied by the
manufacturer (B1, ø36
mm).

STARTING UP

Dispose of the packaging
according to the applicable
regulations.
Remove the top part of the
cleaner to fill the water (13
litres) and then the foam
is killer (Alto Foam STOP). Do
not yet connect the power
cable to a live mains socket!
• Open the two clips and
remove the top part of
the cleaner (Fig. 2).
• Fill the tank as far as the
top mark (MAX) on the
are bracket (Fig. 3/1) with
water.
• Add four sealing caps
of foam killer to the
water.
ATTENTION!
Before closing the tank sub-
sequently, check the elbow
(Fig. 3/2) for correct sea-
ting on the inlet fitting. The
elbow must be inserted as
far as possible into the
fitting, otherwise the top
part of the cleaner can not
be positioned on the tank.
• Place the top part of the
cleaner on the tank and
fasten it with both clips.
• Insert the suction hose
into the inlet fitting of
the cleaner (Fig. 4).
- Please note: The hose
coupling is provided
with a groove and
the inlet fitting with
a click detent.
• Install the attachments
on the suction hose.
ELECTRICAL
CONNECTION
The operating voltage
stated on the type plate
must match the mains
voltage.
NOTE!
Regularly inspect the power
cable for damage (eg
formation of cracks or age-
ing). If damage is detected,
the cable must replaced by
a type as specified,ðsee
"Specifications".
Do not use extension cords,
coupling devices and adap-
ters when vacuuming pro-
pellant charge powder resi-
dues.
11