Table of Contents
Advertisement
aero / SQ
Operator's
Wet/Dry
Manual
Vacuum
READ THIS BOOK
This book has important information for the use and safe operation of this machine. Failure to read
this book prior to operating or attempting any service or maintenance procedure to your ALTO
machine could result in injury to you or to other personnel; damage to the machine or to other property
could occur as well. You must have training in the operation of this machine before using it. If your
operator(s) cannot read English, have this manual explained fully before attempting to operate this
machine.
All directions given in this book are as seen from the operator's position at the rear of the machine.
For new books write to: ALTO U.S. Inc., 2100 Highway 265, Springdale, Arkansas 72764.
Form No. 70204A
3/00
WAP TECHNOLOGY
Printed in the U.S.A.
Advertisement
Table of Contents
Related Manuals for Alto Aero SQ series
Summary of Contents for Alto Aero SQ series
- Page 1 This book has important information for the use and safe operation of this machine. Failure to read this book prior to operating or attempting any service or maintenance procedure to your ALTO machine could result in injury to you or to other personnel; damage to the machine or to other property could occur as well.
-
Page 2: Table Of Contents
Table of Contents Important Safety Instructions ..................3 Specifications and Accessories ................5 Grounding Instructions ..................... 6 How To Assemble the Machine ................7 How To Prepare The Machine For Operation ............7 Machine Operation ....................8 Maintenance and Repair ..................9 Troubleshooting ....................... -
Page 3: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS WARNING AVERTISSEMENT ADVERTENCIA DANGER: Failure to read and observe all DANGER statements could result in severe bodily injury or death. Read and observe all DANGER statements found in your Owner's Manual and on your machine. WARNING: Failure to read and observe all WARNING statements could result in injury to you or to other personnel;... - Page 4 DANGER: Failure to read the Owner's Manual prior to operating or attempting any service or maintenance procedure to your Wap Technology machine could result in injury to you or to other personnel; damage to the machine or to other property could occur as well.
-
Page 5: Specifications And Accessories
SPECIFICATIONS & ACCESSORIES Model SQ 10 Gal. SQ 15 Gal. SQ 17 Gal. aero 5 Gal. aero 7 Gal. Voltage 120 V 120 V 120 V 120 V 120 V Frequency 60 Hz 60 Hz 60 Hz 60 Hz 60 Hz Power 1200 Watts 1200 Watts... -
Page 6: Grounding Instructions
GROUNDING INSTRUCTIONS This appliance must be grounded. If it should malfunction or breakdown, grounding provides a path of least resistance for electric current to reduce the risk of electric shock. This appliance is equipped with a cord having an equipment- grounding conductor and grounding plug. -
Page 7: How To Assemble The Machine
HOW TO ASSEMBLE THE MACHINE CAUTION! On delivery, the accessories - are lying in the tank and must be removed before the machine is used for the first time. See figure 2. To assemble the machine, remove the machine top section: The power cord must not yet be inserted into a plug socket. -
Page 8: Machine Operation
MACHINE OPERATION Picking Up Dry Substances Before picking up dry substances, the bag-type filter should always be installed in the tank. It is then easy to dispose of the material picked up and the service life of the main filter element is significantly increased. Dry cleaning without bag-type filter is also possible. -
Page 9: Maintenance And Repair
MACHINE OPERATION Changing The Bag Type Filter 1. Close the bag-type filter sleeve with the slide (Figure 9). 2. Pull the bag-type filter sleeve off the inlet fitting. 3. Dispose of the used bag-type filter in accordance with the local waste disposal regulations. 4. -
Page 10: Troubleshooting
TROUBLESHOOTING Problem Cause Action Motor does not start. 1. Reset the fuse 1. The fuse or plug socket has blown. 2. Overload protection switch has tripped. 2. Allow the machine to cool down approximately 5 minutes; if the machine does not start again automatically, contact the Service Dept. -
Page 11: Parts And Service
aero / SQ Wet/Dry Vacuum Section II Parts and Service (70204A) Page -11- WAP TECHNOLOGY Wet/Dry Vacuums Operator's Manual Page -11- WAP TECHNOLOGY Wet/Dry Vacuums Operator's Manual... -
Page 12: Assembly Drawing For Aero 5 Gallon And Aero 7 As/E
WAP TECHNOLOGY aero 5 Gallon aero 7 AS/E Assembly Drawing 3/00 Page -12- WAP TECHNOLOGY Wet/Dry Vacuums Operator's Manual... -
Page 13: Parts List
WAP TECHNOLOGY aero 5 Gallon aero 7 AS/E Assembly Parts List 3/00 Ref. Part No. Description 11753 Filter Element, Short 60606 Float 60607 Cage, Float 61156 Filter Bag, aero 5 (pkg. of 5) 60910 Filter Bag, aero 7 (pkg. of 5) 2364 Cap Nut 2793... -
Page 14: Assembly Drawing For Sq 10 And 15 Gallon
WAP TECHNOLOGY SQ 10 & 15 Gallon Assembly Drawing 3/00 Page -14- WAP TECHNOLOGY Wet/Dry Vacuums Operator's Manual... -
Page 15: Parts List
WAP TECHNOLOGY SQ 10 &15 Gallon Assembly Parts List 3/00 Ref. Part No. Description 47014 Ring, Foam Rubber 47006 Silencer 44239 Lower Housing, SQ. 26792 Ground Contact SQ. 10 11253 Screw, 50mm x 20mm 11222 Packing Ring, Gasket 11256 Screw, 35mm x 18mm 48421 Terminal Block 11835... -
Page 16: Assembly Drawing For Sq 17 Gallon
WAP TECHNOLOGY SQ 17 Gallon Assembly Drawing 3/00 Page -16- WAP TECHNOLOGY Wet/Dry Vacuums Operator's Manual... -
Page 17: Parts List
WAP TECHNOLOGY SQ 17 Gallon Assembly Parts List 3/00 Ref. Part No. Description Ref. Part No. Description 5103 Curved Wand, Chrome 11565 Screw, 50 x 18 5067 Rubber Nozzle 46418 Filter Frame 47429 Filter Bag, SQ. 17 (5 pcs.) 45692 Deflector 15365 Hose, Vac 13' x 36 mm... - Page 18 NOTES Page -18- WAP TECHNOLOGY Wet/Dry Vacuums Operator's Manual...
- Page 19 (501) 750-1000 Customer Service - 1-800-253-0367 SALES SUBSIDIARIES Technical Service - 1-800-356-7274 ALTO Canada Ltd., Rexdale Ontario ALTO U.S. Inc., Bowling Green, Ohio 43402 24 Constellation Ct. 1100 Haskins (416) 675-5830 ALTO U.S. Inc., Clearwater, Florida 33765 ALTO Overseas Inc., Sydney (Australia) 1500 N.
- Page 20 WAP TECHNOLOGY WARRANTY This Wap Technology Industrial/Commercial Product is warranted to be free from defects in materials and workmanship under normal use and service for a period of two years from the date of purchase, when operated and maintained in accordance with Wap Technology's Maintenance and Operations instructions. This warranty is extended only to the original purchaser for use of the product.