Installation Of Hydraulic Deflector Kit Ber0079 - Blizzard B74C Operator And Parts Manual

Installation of Hydraulic Deflector BER0079A
(Figures 13 to 18)
1. Install the chute according to the instructions
in the snowblower Operator Manual.
2. Figure 13: Remove the two manual adjustment
knobs (item 1) and bolts (item 2) from each
side of deflector and replace with two 5/16" NC
x 3/4" carriage bolts (item 3), using original
nylon washers (item 5-6) and two 5/16" NC
nylon insert locknuts (item 4). Place one nylon
washer outside the deflector and one (item 6)
between the deflector and the chute base. Do
not tighten completely to allow deflector
movement by hand.
3. Figures 14 & 15: Place the deflector bracket
(item1) on center of chute deflector (item 2),
flush with bottom edge of deflector (detail A).
Using this bracket as a template, drill four 9/32"
holes into deflector.
4. Figure 15: Bolt in place with four 1/4" x 3/4"
allen flat socket head capscrews (item 3), 1/4"
lockwashers and 1/4"NC hex nuts (item 4),
with the capscrews heads inside the chute.
Tighten so that capscrews heads sink into
deflector surface.
5. Figure 15: Retract hydraulic cylinder rod
(item 5) completely and secure to deflector
bracket (item 1) and deflector base bracket
(item 6), using the two cylinder pins (item 7)
and the two cotter pins (item 8). Direct the
cylinder ports toward the snowblower center.
6. Figure 15: Open deflector to maximum so that
actuator rod retracts
deflector base bracket (item 6) on the center
rear of chute and using the bracket as a
template, drill four 9/32" holes into chute.
7. Figure 15: Bolt deflector base bracket (item 6)
to chute using four 1/4" x 3/4" allen flat socket
capscrews (item 9), 1/4" lockwashers and
1/4"NC hex nuts (item 10), with the capscrews
heads inside the chute. Tighten so that
capscrews heads sink into chute base surface.
OM 0410SB-A
ASSEMBLY
completely. Place
21
Figure 13
Figure 14
Figure 15