Blizzard B74C Operator And Parts Manual page 21

5. Figure 10: Install a 0.052" flow
restrictor (item 2) in each motor input
(item 1).
6. Figure 10: NOT
Connect the two hoses (item 3) on
the motor flow restrictors (item 2).
Direct the hose elbows toward the
snowblower upper arm.
7. Figure 10: NOT INCLUDED: Run
hoses on the snowblower with
suitable bend, staying away from
sharp edges, nor compromise the
snowblower maintenance. Attach to
the right or left snowblower three
point arm with a hose clamp (item 4),
a 3/8"NC x 1 1/2" bolt (item 5) and a
3/8"NC nylon insert locknut (item 6).
8. NOT INCLUDED: Connect hoses to
tractor and make sure to raise and
lower the snowblower in extreme
positions, and check if hoses are
long enough to not interfere with any
parts. Attach hoses with nylon tie
wrap to appropriate places. Rotate
the chute to the right and to the left.
9. Figure 11: Motor
Push the motor toward the chute as
to well set the gear teeth (item 1)
without leaving any play between
teeth. Firmly tighten the four 3/8"NC
x 1" bolts (item 2). If the rotation does
not operate correctly,
adjustment.
10. Figure 11: Install the gear shield
(item 3) and secure with two 1/4"NC
x 3/4" bolts (item 4), two 1/4"
lockwashers and two 1/4"NC nuts
(items 5-6), as illustrated.
OM 0410SB-A
ASSEMBLY
INCLUDED:
Figure 10
Figure 11
adjustment:
redo the
19