Table of Contents
Advertisement
INSTALLATION INSTRUCTIONS
NOTE: For easier assembly and installation,
vehicle and all snowplow components should
be on a smooth, level, hard surface, such as
concrete.
1. Remove the tow hooks. Notch the lower plastic
portion of the bumper to fi t, as shown below.
Notch bumper as shown
2. Beginning with the passenger-side mount, align
the forward mount holes with tow hook holes in
frame. Reinstall the tow hook and fasteners and
tighten according to the torque charts provided.
Repeat on the opposite side.
3. Position the rear brackets around the front
stabilizer bar as shown in the photo below.
Loosely attach the rear brackets to the mounts
using three 1/2" x 1-1/4" cap screws and locknuts
on each mount.
Rear
Bracket
1/2" x 1-1/4"
Cap Screw
Lit. No. 41606, Rev. 01
UNDERCARRIAGE INSTALLATION
Stabilizer
Bar
4. Insert a 1/2" x 1-3/4" cap screw and washer
through the rectangular opening in the inner
surface of the frame, through the frame and the
rear bracket. Secure loosely with a 1/2" locknut.
Adjust the position of the rear brackets upwards as
far as possible and secure the 1-3/4" fastener, as
well as the three 1-1/4" cap screws from Step 3.
1/2" x 1-3/4" Cap Screw
and Washer
Rectangular
opening in the
inner frame.
Use caution not to pinch, cut or drill through
any wires or hoses running along the frame rail.
5. On the passenger's side, drill two 17/32" diameter
holes through the vehicle frame using the
rearmost 9/16" holes in the brackets as guides.
5
CAUTION
Drill 17/32" dia. holes
through the frame.
Rectangular
Opening
January 1, 2012
Advertisement
Table of Contents
