Toyota 2016 Tacoma Owner's Manual page 97

■
Setting display automatic cancelation
In the following situations, a setting display in which the settings can be
changed through the meter control switches will automatically be turned off.
●
When a warning message appears while the setting display is displayed
●
When the vehicle begins to move while the setting display is displayed
■
Tire inflation pressure (vehicles with tire pressure warning system)
●
It may take a few minutes to display the tire inflation pressure after the
engine switch is turned to the "ON" position (vehicles without a smart key
system) or IGNITION ON mode (vehicles with a smart key system). It may
also take a few minutes to display the tire inflation pressure after inflation
pressure has been adjusted.
●
"---" may be displayed if the tire position information cannot be determined
due to unfavorable radio wave conditions.
●
Tire inflation pressure changes with temperature. The displayed values may
also be different from the values measured using a tire pressure gauge.
■
Liquid crystal display
P. 91
WARNING
■
The information display at low temperatures
P. 92
■
Cautions during setting up the display
As the engine needs to be running during setting up the display, ensure that
the vehicle is parked in a place with adequate ventilation. In a closed area
such as a garage, exhaust gases including harmful carbon monoxide (CO)
may collect and enter the vehicle. This may lead to death or a serious
health hazard.
NOTICE
■
During setting up the display
To prevent battery discharge, ensure that the engine is running while setting
up the display features.
2. Instrument cluster
I n f o r ma t i o n P r o v i d e d b y :
97
2