Toyota 2016 Tacoma Owner's Manual page 425

■
Reprogramming a single HomeLink
When the following procedure is performed, buttons which already
have devices registered to them can be overwritten:
1
With one hand, press and hold the desired HomeLink
2
When the HomeLink
the HomeLink
1
(it takes 20 seconds for the HomeLink
flashing).
Operating the HomeLink
Press the appropriate HomeLink
light should turn on.
Garage door operation indicators
The status of the opening and
closing of a garage door is shown
by the indicators.
1
Opening
2
Closing
This function is only available if the
garage door opener motor used is
a compatible device. (To check
device compatibility,
www.HomeLink.com.)
Color
Orange (flashing)
Green
Red (flashing)
The indicators can operate within approximately 820 ft. (250 m) of
the garage door. However, if there are obstructions between the
garage door and the vehicle, such as houses and trees, feedback
signals from the garage door may not be received.
To recall the previous door operation status, press and release
either HomeLink
simultaneously. The last recorded status will be displayed for 3 sec-
onds.
®
indicator starts flashing orange, release
®
button and perform "Programming HomeLink
®
®
refer to
®
buttons
I n f o r ma t i o n P r o v i d e d b y :
6-4. Other interior features
®
button
®
button. The HomeLink
Status
Currently opening/closing
Opening/closing has completed
Feedback signals cannot be received
and or
425
®
button.
®
indicator to start
®
indicator
and
"
6